|
Product Description
The bushing is made from polyurethane as opposed to the OEM rubber bushing
material which is much softer. The kit comes supplied with a specific stainless
steel sleeve and a packet of copper grease/anti-seize. It is a direct
replacement for the soft OEM front mount bushing and fits with absolutely no
modification. Installation takes about 20 minutes. The most difficult part is
removing the factory bushing from the mount which basically needs destroying to
get it out, but once accomplished, the Powerflex bushing fits in easily. After
installation you should notice an immediate improvement in shifter feel and
on/off throttle vehicle response due to significantly reduced front-to-back
movement of the engine under on/off throttle conditions.
The car should seem to "buck" less under light throttle cruising, and much
less engine movement during the disengagement of the clutch under light
throttle. There is a very slight amount of increased vibration at idle only,
which is to be expected, however this additional vibration is only felt through
the steering wheel to the driver, your passengers would never know that you
changed anything if you didn't tell them what you did. This vibration is so
minor that it would not be worth mentioning it but I am sure that many owners
would ask the question before committing to this install. It is also usual for
this initial increase in vibration will go away after a short period of time (a
couple weeks) once the bushing settles in.
Fits: Mitsubishi Lancer Evolution VIII/IX and MR (6 speed).
Installation Rating: Easy : 30
Minutes or less
Part # PFF44-106
|
Rexpeed Carbon Fiber Hood Damper - EVO 8/9
