Install Tips: Tyrant CF Vortex Generator ::</title>
 Home   Help   Testimonials   New Arrivals   View Cart   Install Tips 
Air Intake
Blow Off Valve
Boost Controllers
Clutch - Trans

Deals of the Day

Excellent customer service...I placed an order but I had the wrong city listed on my shipping address. Laeli called UPS and got it straightened out before it had a chance to get sent to the incorrect address! Thank you very much Lancershop!!

View All Testimonials

Write Your Own Testimonial

Recently Viewed
No recent products.
Gift Cards
Gift certificates

TRENDING: Rexpeed | AMS | Ultimate Racing | Engine Parts | Buschur Racing

Install Tips: Tyrant CF Vortex Generator

Installing Tyrant Carbon Fiber Vortex : Lancer Evolution VIII


Published By:  Justin Hamel  (May 1st, 2005 at 9:32pm)

Product: Tyrant Carbon Fiber Vortex Generator


Tyrant performance really outdid themselves with this part. The carbon fiber and the finish is outstanding. I originally had the MR vortex generator on my car, and I had to remove that before installation of the Tyrant. I'm a carbon fiber-aholic and this part is another perfect fix to feed my addiction :-) Thanks to Tyrant performance for this great part. 


1. You will want to unclip the body trim that runs from the roof line to the bottom of the trunk. We suggest popping the trunk, and starting there and working your way up the roof line. You will need to do this on the drivers and passenger side of the EVO.

Tech Tip: Be very careful when removing these, they take a little pressure to unclip them.

2. Starting on the passenger side, we test fitted the Tyrant vortex to get the feel of the install. We suggest getting a buddy to give you a hand at this point and a couple chairs to get a better angle on things. Once you get the feel of this install, take the protective layer off the double sided tape. We suggest starting in the middle near the antenna mast and then lining up on both sides. Once you confirm it is in place, push down to secure the generator.

Tech Tip: We suggest heating up the generator tape with a hairdryer to heat up the adhesive on the backside.


3. Secure the molding trim pieces by pushing them back in place.





Want to buy this part? Read More>> Did You Enjoy Reading This Article? Read More>> Become A Member Today! Access To More Articles>>



Online Users
» 1316 Shoppers

Your cart
Welcome to LancerShop! In order to shop with us, you must create an account.

Your Cart is Empty!
» View cart
» Checkout
» Wish list
» Where's my stuff?

Your Account


Remember Me
Recover password

If Javascript is disabled in your browser click here


» Sales Inquiries
» Contact us
» Privacy statement
» Recover password

  1-888-554-6447 --  -- URL:
© 2002-2023 All Rights Reserved.
Rexpeed Carbon Fiber Parts